The online user manual PDF can be found on this website >> under the "Support" tab.

Produces 5600K daylight-balanced output
508 LED panel with a 60° beam angle
Weighs 2.05 lbs
Dimming is easy via a knob that adjusts light intensity from 100-0% with color temperature shift
An LED gauge on the back panel facilitates monitoring of remaining power

Front of Genaray light kit Back of Genaray light kit

How to set up:

Set up the light
1. Screw the ballhead mounting adapter into the mounting hole on the back of the fixture under the LED power indicator.
Secure the power source
1. The kit comes with an AC adapter, so you can plug the cable into a wall.
2. However, if you need to use the batteries:
  1. The light needs to have 2 batteries connected to have power.
  2. To insert the batteries, push the battery down to lock it in place until a click is heard.
  3. To remove the batteries, push the red battery release button.
Adjust the position of the light fixture
1. To position the light fixture, loosen the ratchet handle to allow the ball to move freely.
  1. Be sure to keep a hand on the light while positioning, to prevent it from falling.
2. Once positioned to your liking, tighten the ratchet handle to secure the position.
Adjust the strength of the light
1. Turn the On-Off/Dimmer dial to 'On'
2. You can adjust the light output to anywhere between 100% to 0% by rotating the dial
3. There should be an additional dial on the back allowing you to adjust the light's color temperature. You can set it anywhere between 3200 degrees K and 5600 degrees K.
4. Use the diffusion filter to soften and spread the light. You can pop this in the front of the LEDs.
Optional:
1. You can stack up to 3 LED panels with the Genaray Lights
Warning!
1. Do not stare directly at the lights when they are turned on and make sure to keep the light kit away from liquids or flammable gases.